Matching You with a Pre-Screened Smog Check Center You will Love
Free Online Smog Check Diagnosis
$500 Free Consumer Repair Assistance
Failed Emissions Test
How to Pass the Test
Who Else Wants To Pass the Smog Check
Miles: 
Which Type Should I Choose?
 
   
    Forum > Failed Smog Test > Question

Join the community and post your questions. Ask-A-Tech right now!
 
 



Failed Smog Test
 

2015 Porsche Cayman 981 Emission Monitoring Not Ready

Hi, I need to compete the CA smog test in order to transfer my title and change ownership. But it failed the smog test because the Catalyst Monitoring Not Ready and Oxygen Sensor Monitoring Not Ready. What do I need to make it ready? Or what is the drive cycle on this vehicle? Thanks.

Answer:  

Typically driving your Porsche for a few hundred miles over the course of a few days (in both city and highway traffic conditions) is enough to get the emission monitors ready for the smog test. Sometimes however the driving pattern required to complete the emission monitors are not met during normal city/highway driving, and following the required and specific Porsche drive cycle/pattern is needed.

Below we outline the driving cycle you'll need to perform in order to get your Porsche's OBD-II emission monitors to become READY or COMPLETE. Perform the entire drive cycle. Completing only one portion of the drive cycle will not make the particular monitor which you're trying to make READY complete. The entire drive cycle must be performed every time you attempt the set any of the monitors. Please take extra caution while performing drive cycle on public roadways. If you think you will be unable to follow the Porsche Cayman drive cycle below safely, seek the assistance of a smog check repair station or Porsche dealership. They will be able to complete the drive cycle in-house and on a dynamometer.

Porsche Cayman Drive Cycle - OBDII Emission Monitor Ready Driving Pattern 

Prior to starting the driving cycle ensure your Porsche's fuel tank is between 1/4 and 3/4 full. Also do not exceed 3,000 rpm or 60 mph during any portion of the drive cycle. Take extra caution when perform the Porsche drive cycle on public roadways. if you think you will be unable to safely perform the drive cycle please seek assistance from an experienced Porsche mechanic or smog check repair center. 

A. Start your Porsche 911 and let it idle for approximately 2 1/2 minutes. This will allow the ECU to diagnose oxygen sensor aging; meaning the computer will be monitoring the oxygen sensor warm-up period and reaction to rising exhaust temperatures. During this period the ECU is also testing the Secondary Air Injection system. 

B. Begin driving. Accelerate to 20-30 MPH and maintain your speed for 3 1/2 minutes. The ECU will be testing catalytic converter efficiency. 

C. Next, accelerate to 40-60 MPH. Once again maintain steady speed, this time for approximately 15 minutes. The EVAP system is now being tested along with adaptation range (2) and the oxygen sensor (switching). 

D. Decelerate and come to a complete stop. If equipped with a manual transmission, idle in neutral for 3 minutes. If equipped with an automatic Tiptronic transmission, idle in drive (D) for 3 minutes. Adaptation range (2) is now being tested.

E. Repeat steps B through D. Drive cycle complete.

Should the Catalyst Monitor and/or the Oxygen Sensor Monitor not complete after completing the drive cycle a few time, we'd recommend having your vehicle inspected by either a Porsche dealer repair center or reputable smog check test and repair center. Each of your vehicle's emission monitors have strict input parameters which must be met before the emission monitor test is initiated. For example, if the your vehicle's engine never achieves closed-loop, the Catalyst monitor will not run. Or, should the ECT (engine coolant temperature) sensor indicate an irregular engine temperature, the air injection monitor may not initiate. It's possible that neither of these two conditions trigger the check engine light to turn on, but they will stop the drive cycle from making the required monitors ready. Having an auto repair shop attempt to complete the drive cycle in-house will allow them to monitor all system parameters while the drive cycle is in progress. They can pinpoint what may be causing your Porsche's emission monitors to not set.


posted by SmogTips Support
 


Related Porsche questions and answers you might find useful:

How To Perform a Porsche Cayman Drive Cycle? by George

Aftermarket Turbo Kit for a 1994 Porsche Cayman by Roger

Can an Out of State Porsche 911 Pass the CA Smog Check? by MARK

Porsche Cayman Smog Check with Modified Engine by Roger

Porsche 911 GTS Drive Cycle OBDII Not Ready by Karen