Matching You with a Pre-Screened Smog Check Center You will Love
Free Online Smog Check Diagnosis
$500 Free Consumer Repair Assistance
Failed Emissions Test
How to Pass the Test
Who Else Wants To Pass the Smog Check
Miles: 
Which Type Should I Choose?
 
   
    Forum > Smog Check Repair > Question

Join the community and post your questions. Ask-A-Tech right now!
 
 



Smog Check Repair
 

Honda Pilot Drive Cycle

Hi. I could find how I should drive my 2013 Honda Pilot for it to get the emission monitors ready for the smog test, specifically the smog check catalytic converter monitor. It’s not ready and can not pass the smog check at this moment. Please help me. How can I drive it? Thanks.

Answer:  

In most cases, your vehicle's emission monitors should run during normal driving on both city and highway traffic conditions and over the course of 200 to 300 miles. However, due to different driving habits, the criteria required to run a monitor may not always be met. Following the Honda Pilot drive cycle below should allow the emission monitors to complete. The drive cycle must be followed accurately.

Take extra caution when performing the drive cycle on public roadways. Perform the drive cycle at your own risk. If you feel you might not be able to perform the drive cycle safely, or obey all traffic laws, seek the assistance of a smog check repair station which will be able to perform the drive cycle on a dynamometer, utilizing specialized OBD II drive cycle readiness tools/scanner/computer.

 

Emission "monitors" are internal self-tests which the engine control unit (ECU) performs to ensure your Pilot is not polluting and is running efficiently. The entire process of self-testing various emission control systems is called a Drive Cycle.

How To Perform a Honda Pilot Drive Cycle

The following is a Honda OBDII Drive Cycle Pattern. (Obey all traffic laws while performing drive cycles. Perform acceleration steps only on highways)

COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.

IDLE TIME: Run your Honda’s engine (do not drive) for 2 1/2 minutes with the air conditioner on and rear defroster on. During this period the ECU will be running the Oxygen Sensor Heater self-test, Air Injection System Passive Air test, EVAP Purge "No Flow" test, Misfire Detection.

ACCELERATE: Turn off the air conditioner and rear defroster and begin driving. As soon as possible apply half throttle until 55mph is reached. The ECU will now run self-tests on the Misfire Detection, Fuel Trim, and EVAP Purge Flow.

HOLD STEADY: Now hold your vehicle speed steady at 55mph for three minutes. During this time the Oxygen Sensor O2 response, Air Intrusive (AIS System), EGR Flow, Purge Valve, Misfire Detection, and Fuel Trim diagnostics will be performed.

DECELERATE: During this step you want to slowly let off the accelerator pedal. Do not brake or shift your Honda in order to slow down. It is important to let the vehicle coast along gradually slowing down to 20 mph. The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims.

ACCELERATE: Go ahead and accelerate again at 3/4 throttle until 55-60mph is reached. This will perform the same self tests as during the first acceleration step.

HOLD STEADY: Hold steady speed once again. This time at 55mph for five minutes. During this time, in addition to running the self-tests as during the first HOLD STEADY step, the ECU will perform the catalyst monitor diagnostics. If the catalyst (Catalytic Converter) is marginal or the battery has been disconnected, it may take 5 complete driving cycles to determine the state of the catalyst,or in order to Complete the CAT Monitor.

DECELERATE: This will perform the same diagnostics as in the first Deceleration. Remember not to press your Honda’s brake or shift gears during deceleration.
This should complete the drive cycle on your Honda Pilot. To ensure all monitors are complete use a scan tool to view the monitors. You may want to complete the drive cycle 2-3 times.


posted by SmogTips Support
 


Related Honda questions and answers you might find useful:

Honda Accord Needs CA Smog Check But Is Out of State by Mel

2004 Honda Accord LX Catalytic Converter Issue by Ryan

Honda Civic SI CAT and EVAP Not Ready by Dallas

Buying 2013 Honda Fit from PA and Registering in CA by mary

2011 Honda Fit Replaced Speed Sensor for P0722 by Ron